Results 1 to 2 of 2
-
04-16-2006 #1
Registered User
- Join Date
- Aug 2004
- Location
- NJ
- Posts
- 1,295
Building custom intake plumbing......
I was thinking about building some custom plumbing, to feed my throttle body.
I was thinking of two 3 inch pipes, they tuck down by the radiator near the bottom with cone filters, and then work there way up and merge into the throttle body.
Is 3 inch large enough? should I use 4 inch?? It's GM's 572/620HP version, so I was worried about airflow a little. I dont want to starve the engine for air.
Thanks in advance!!!!
John
-
04-16-2006 #2
Registered User
- Join Date
- Aug 2004
- Location
- Dunwoody, GA
- Posts
- 4,984
two 3" pipes merging into a 4" pipe should do you well. what size is the the TB opening? i would use that as the final size and not just neck it down right before the TB. that's if it happens to be smaller than 4"
Trey
"The early bird may get the worm, but the second mouse gets the cheese."
~ Jon Hammond
1979 WS6 Trans Am stock LT1/T56 drive train out of my Formula. BMW M-parallel rims. C5/C6 brakes
build thread https://www.pro-touring.com/showthre...ghlight=begins
Reply With Quote
