Results 1 to 11 of 11
Thread: Could they be stamped wrong?
Threaded View
-
08-15-2004 #1
Registered User
- Join Date
- Oct 2003
- Location
- Arvada, Co
- Posts
- 2,119
Could they be stamped wrong?
Ok, I started to fit the pass side DSE minitub and it will not fit. The drivers went in fine. I did replace the pass outer wheelhouse and that went in fine with a little tweaking to get a good fit. The outer is flush against the factory flanges. When I try to fit the minitub and use the alignment holes the top of the tub flange is about 1/2" of of the outers flange and I can not move it closer with out bending the inners flange. I hope that makes sense. I will take some pics on Monday. I double checked the cuts for the tub and they are the same as the drivers side. Any ideas would be helpful.
Thanks
Brian
-
Reply With Quote
