Advice needed

[carson]

Hi all,
I need some advice to move forward. I recently got my car back from media blasting, and while I am not overly surprised, it's worse than I thought.

From what I can tell, it needs

• the full passenger quarter, and maybe the drivers.
• roof skin with drip rails
• rear trunk filler panel
• deck lid
• passenger door skin
• tail panel
• upper dash
• both tulip panels
• full floor?

I need some input from people that know more than me on how best to proceed. I see that the Dynacorn are $13.5K and come with doors and truck lid, this seems like it would be a cheaper/faster route than sentencing the car to either body shop jail for years, or having me hack at it until it is minimally acceptable. What level of quality are these bodies? Can I just swap my VIN/body tags over?

I am also a little afraid of the squareness of the whole body after seeing the floor pan around the transmission tunnel. Are there any known points that can be measured to confirm square, or should I just pick some repeatable locations?



Thank you all in advance for your help.
Pictures: