Damper position...

[roguegeek]

I'm installing a Wegner WAK033 accessory drive onto an LS427/570. The kit came with the ATI Super Damper ATI917776. I followed both ATI and GM's instructions for installing a damper (both were extremely similar) and it's not seating as far back as it should be going. It's about 3/4" off the block cover. ATI said it should be about 1/4" off. It physically can't move back any further. Installing the rest of the accessory drive kit confirmed my crank pulley is about 1/2" out of alignment with the rest of the pulleys. I'm waiting for a call back from Wegner, but I figure I'd throw this question out to you guys to see if you knew what was up.



Thanks.