New bake system layout

[Sbeck09]

I'm about to start running hard lines around my chassis for the brake system. It is all brand new disc brake equipment that will be fed by a 1" Baer Remaster with a proportioning valve. This is all scratch built on a clean sheet.



How important is the position of the T-fittings at the front and rear? As in, if the front/rear T is closer to the left or the right side, does that create a bias of pressure to the closest wheel first. I noticed a number of OEM systems are not totally centered, but I'd like my brakes to work as evenly as possible. My brain says that the closest wheel would bite first, but I'm hoping one of you knows some facts.

Thanks!