Motor/trans angle?

[c4racer2]

iPhone level should be fine. I use a digital level from Home Depot $35.



- - - Updated - - -



Be careful...lots of opportunities to mis-measure. Much better to use a dummy block and trans case.

I am only using this set-up to determine how much of the stock tunnel to remove. And I have removed more than is needed - so no issue there. I am not building a trans mount - I am using a SpeetTech mount. I will get that installed and see if the trans fits where I expect it to. And then I'll be ready to just do a final install with the motor. Just easier than dropping the motor in just for clearancing the tunnel. It's not exactly a precision job!