Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 1 of 1
    1. #1
      Join Date
      Apr 2016
      Location
      clarkston, mi
      Posts
      84
      Country Flag: United States

      pinion angle and trans angle parallel but offset

      i was lucky on my monte, i had 6 degree neg (down) trans angle, rear end neg down 2 degrees, i shimed the trans up 8 degrees, now i am parallel, but with 2 degree angles, so the u-joints bearings will rotate. a lot of guy run 1 degree differance, and some run 0 degree differance. when you are running the driveshaft is going up and down so the bearing move. some guys with 0 degree lube the bearing after every race. do not put your magnetic angle meter on the trans pan, they are not parallel to the yoke coming out of the trans, and the rear end is hard to find a surface parellel to the pinion. I TAKE MY ANGLES OFF THE UJOINT CAPS, BUT FIRST YOU TURN YOUR METER CROSS CAR AND MAKE SURE YOU ARE VERTICAL, VERY IMPORTANT. it is a pain in the butt to check your angles laying on your back, cause you are at the angle of the driveshaft, and everything looks differant. the vibration went away after adjusting angle Name:  IMG_1596[1].jpg
Views: 259
Size:  274.9 KBName:  IMG_1594[1].jpg
Views: 220
Size:  248.9 KBName:  IMG_1595[1].jpg
Views: 213
Size:  195.7 KB




    Advertise on Pro-Touring.com