Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 5 of 5
    1. #1
      Join Date
      Nov 2016
      Posts
      1

      1969 Camaro ignition switch remove and replace

      I need to change steering wheels and replace the ignition switch. I am an old man that needs step by step instruction.



    2. #2
      Join Date
      Mar 2004
      Location
      Mid-Michigan
      Posts
      2,764
      Country Flag: United States
      Remove the steering wheel and lock plate. When you look down into the shift bowl you "should" see a small hole towards the back of the lock cylinder. If not, dig a round a little with a sharp pick or scratch awl. When you see the hole shove a straightened paper clip or small drill bit in to depress the pin to unlock the cylinder. It should pull right out once the pin is depressed. I think you also have to have the key in the ignition, not sure about that though, been a while since I have worked on one. :(
      Mark
      Mark:
      "Bad Ast" Astro Van. Just because I did it... Doesn't mean it's possible...
      This my Bad Ast thread...
      https://www.pro-touring.com/showthre...roject-Faze-II
      This is my Fotki album...
      http://astroracer.fotki.com/

    3. #3
      Join Date
      Oct 2010
      Location
      Sacramento, CA
      Posts
      246
      Country Flag: United States
      Ignition or key? Two different things. The ignition switch is located on top of the column down near the firewall and is mounted with small screws.
      Rick - 1969 Camaro - LS1 driven daily

    4. #4
      Join Date
      Aug 2007
      Location
      Jonesboro, Arkansas
      Posts
      2,506
      Country Flag: United States
      Isn't the ignition switch tumbler on a '69 in the steering column? Which would make the key in the same place. You do have to have the key in the switch to remove after depressing the pin in the hole that you put the straightened out paper clip or very small drill bit in. you will have to put the key into the "acc" mode, insert the paper clip, and continue to turn to the left pulling slightly on the key until the tumbler comes out. Not hard at all. This is the way to remove the tumbler out of my '68, I'm guessing the '69 is the same.

      Carl Wilson
      1968 Camaro - T-56 6 speed - 383 Stroker, 2014 Mustang GT seats. FiTech EFI, Tanks Inc. Tank with Deutschwerks fuel pump.

    5. #5
      Join Date
      Mar 2004
      Location
      Mid-Michigan
      Posts
      2,764
      Country Flag: United States
      What Rick is referring to is the actual ignition switch. It is down at the base of the steering column and is actuated with a rod when the key is turned. The OP stated he was removing the steering wheel so I understood him to mean the key tumbler as Carl mentioned.
      Mark
      Mark:
      "Bad Ast" Astro Van. Just because I did it... Doesn't mean it's possible...
      This my Bad Ast thread...
      https://www.pro-touring.com/showthre...roject-Faze-II
      This is my Fotki album...
      http://astroracer.fotki.com/




    Advertise on Pro-Touring.com