DSE Rear floater kit install

[mdes0]

Hey folks, looking for some advice. I'm thinking about getting the new DSE floater kit for my 70 Camaro build but I've hit a snag. So here's the story, I have already installed the DSE Quadralink kit in the Camaro and all the brackets are welded to the 12 bolt I plan on using. DSE will sell me the kit without a rear end housing so I'll be able to get the floater ends welded onto my 12 bolt. Here's the problem, I haven't been able to find a shop that can weld the ends on. Since these aren't the traditional torino ends the shops I've talked to don't want to attempt the install since they don't have a jig to lock the ends on square. Anyone on here know of a shop that can install something like this in the MA, NH area?

Thanks,
Matt

[dontlifttoshift]

Sell existing 12 bolt, buy new 12 bolt, take the hit.

Pay someone to machine fixturing ends, take the hit.

Contact MillerBuilt on Lateral-G and see if you can purchase a set of fixture ends from him.

Contact MillerBuilt on Lateral-G and purchase floating setup from him and he will loan the fixturing to you for installation.

[TheJDMan]

Contact DSE and see if you can send them your rear end to install the floater ends. Having said that, it does not take a rocket scientist to make a straight shaft and a couple of bushings to use as an alignment gage to weld the ends on.

[dontlifttoshift]

Yeah, I assumed that he had already asked about sending his housing back.

...while it's not rocket surgery, it must be complicated because I have straightened an awful lot of new housings.