Monster LS2

[ProStreet R/T]

Looks like 1" head spacers and new sleves.. curious to see the specs, 4.5" stroke with a 4.2" bore would be interesting, make for a monster street turbo motor.
500ci SB now that could make things interesting.

[Travis B]

WOW

[Ralph LoGrasso]

WOW is right! I'll take two, actually -- better make it three.

[scottyz]

Who is building that and where did you get that pic? Is it going to actually be 500 cid

[Norwoodx55]

Wow! 4.5" seems like quite a bit of stroke for a 4.2" bore
498.8 inches of aluminum small block would be pretty bitchin' though.

[ProStreet R/T]

Who is building that and where did you get that pic? Is it going to actually be 500 cid

hehe, there is this little gathering in Vegas, you might have heard about it.

4.2 bore and 4.5 stroke is just my guestimation about how they would get to 500ci. The LS2 has (I believe) a 4.40" bore center so they won't be going much over 4.2 bore. I'd like to get a closer look at the crank and guts of the block tho. The rod:stroke ratio won't be too wild with the deck spacers so it should be a pretty reliable combo. I tell ya that thing would be nasty with a single 91mm ish turbo.

[Fuelie Fan]

That thing would be nasty WITHOUT a turbo.

[CarlC]

Yep, it was at SEMA.

[Kenova]

World Products?
Ken

[CarlC]

Take a close look at the picture above for a web address.

[ViperBlue68]

Take a close look at the picture above for a web address.

Here you go guys http://www.erlperformance.com/