Camaro RideTech Tru Turn Full subframe - Gauging Interest- TX

[glr0212]

I have a complete stock subframe built with ridetech parts - first gen camaro. Uppers/lowers/coilovers/musclebar/spindles/New Delphi 600 box. The car is in paint and the subframe is apart at the moment getting the welds cleaned and frame powdercoated. Obviously the stuff has never been run. I figure all in I have a little over $5000 in this setup. If I could get $4000 for it I would let it go. Any feedback appreciated. Single adjustable shocks 550lb springs (small block). Not looking to part it out.

Pictures below are before cleaning up the frame welds and powder coating.

Tru Turn with spindles	1000
Muscle bar	500
Control arms	1300
Coil overs	700
Delphi 600 box	550
Subframe powder coated and welds cleaned	400

[rallystyle]

would you sell just the lee box? what is the ratio?

thanks

also may want to say if the coil overs are singles or nonadjustable and spring rate.

[glr0212]

No, I can't part it out.

If i don't sell it all I am going to need it for my car. It's a quick ratio 12:1.

[dhutton]

Which coilovers? Part numbers? What springs?

Thanks,
Don

[BBBluey]

I'm not seeing for what model/year. Did I miss it?

[glr0212]

single adjustable coil over. 550lb springs. first gen camaro. I believe they are HQ shocks.

I was looking back over the invoice, the box is a New Delphi 600 box, not a Lee.

[BlackHD]

Car looks sweet, what are the specs on your wheel/tire combo? Size, brand etc.

Thanks

[glr0212]

wheels are iforged seneca 18x9.5. 6.25" Backspace

Tire is a 265/35 bfG kdw

I have a little trouble making them fit the way I want. Maybe I'm trying to put the car too low or don't have the alignment right or something.

[BlackHD]

wheels are iforged seneca 18x9.5. 6.25" Backspace

Tire is a 265/35 bfG kdw

I have a little trouble making them fit the way I want. Maybe I'm trying to put the car too low or don't have the alignment right or something.

Thanks, car looks sweet.