Tig Tips

[Camaro Zach]

if you have any tips or questions post up and maybe we can help eachother out or Matt can show us all up lol..


Matt - i figured out why my previous 2 attempts were poor, the tungsten was not sticking far enough out of the cup. I had it about 3/16" and it should be about 3/8" (for this cup, yes its massive) Also found some 3/32 filler.

I think i had it a bit too hot and again the weld is too large. And i was experimenting with some different hand positions so some are a bit wavy ~~~



Does it look like i should be doing anything drastically different? or just fine tune from where i am at.