Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 2 of 2
    1. #1
      Join Date
      Nov 2012
      Posts
      373
      Country Flag: United States

      Efi, ignition and EMI problems

      I finally had enough fighting the FAST efi system in the car(70 camaro) and the "fix" seems to be dumping the msd hei I currently have due to EMI noise and replacing it with a "less-noisy" pro-billet distributor and a Digital6al box with an external coil. I'm not sure yet where to mount the msd box but the passenger fenderwell might get the nod since the ecm is mounted on the drivers fenderwell right behind the headlight. The coil will probably go either inside the cowl or just above the AC delete box...not sure yet. Since all of these changes are designed to get rid of EMI, what can I do better to insulate harnesses and wiring short of grounds, and the grounds to ground the grounds? The noise isn't an rpm related noise like I usually hear in the radio and changes with rpm. This noise comes in the radio and is a constant, high whine when it appears, kills the O2 signal to the efi, then goes away again for a while. The efi goes in to a default mode but runs crappy until I reset the code. Runs great again until it decides it's had enough noise(that's what is suspected anyway) I'm headed to the garage now to start pulling the hei and decuding where to run wires. Any ideas or advise from other electrical guru's would be greatly appreciated. Maybe I should have stayed carbed!!

      1970 Camaro restomod power tour ride
      1966 Buick Special restomod, the never ending project
      1970 GTO My newest retirement project, time to gather parts!


    2. #2
      Join Date
      Sep 2014
      Posts
      130
      Country Flag: United States
      Make all power related grounds to the motor block not the body.

      Ground the sensors to the ECU not the motor or body.

      O2 signal ground to the ECU, O2 heater ground to the motor.

      Another possible source of noise is low impedance injectors and alternators.


    Advertise on Pro-Touring.com