Anyone using CTS-V system

[Alldun5]

I'm trying to keep as much of my 6.0 / 6L90 swap, into my 65 Cutlass, as off the shelf parts. That makes failures on the road much easier.
I'm modifying my core support for the 09-16 CTS-V cooling system. The system supports the 6.2 / 6L90 / supercharged engine, it should handle my 6.0. It's roughly 28.5" wide at the base and 22" tall. I"m using the fans, radiator, aux trans cooler and the AC condenser. It does have the provisions for an inter-cooler, but I'm not going that route. I'm able to use all of the Cadillac trans lines, reservoir tank, steam ports, and possibly the heater hoses as well.
The modification to the core is to replace the lower part of the core support, to accommodate the 28.5" width and drop it approximately 1", so I can attach the 3/4" tall standoffs, to use the Cadillac rubber mounts, and allow the trans lines to cross under the radiator, as designed.



I'm still waiting for the upper mounts (#1 in the top pic) to come in so I can set the correct depth, using all of the Cadillac mounts.
I wish I could use the engine oil cooler too.

[Alldun5]