1963 Ford Falcon Build - RestoMod

[jorgezee1]

You did pull the axles first, right? :-)

I would try some heat. Maybe start at the top on the 3 bolts. See if you can get it loose enough to slip a pry bar in, then work it gently around the perimeter.

Andrew

Hi Andrew, Thanks for the advice I will give it a try tonight when I get home.

The axles are out but I didn't at first notice that there were some copper washers on some of the studs until after I started scrapping off some grime. I pry'd them off thinking that was it, but still a no go. I will give your suggestions a try.

Thanks!