Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 7 of 7
    1. #1
      Join Date
      Nov 2009
      Location
      Austin Texas
      Posts
      640

      Ricks (Resto Mod) new EFI fuel tank

      Got this from ricks yesterday. Its a really nice piece. You can either use their billet fuel hat with 1 or 2 pumps or a GM 5th gen fuel module. I chose 2 Walbro 450 pumps since I will be running e85.


      Got it through Matts Classic Bowties and the service was fantastic as usual.


















    2. #2
      Join Date
      Nov 2006
      Location
      Ma.
      Posts
      5,560
      Country Flag: United States
      Sweet looking setup!
      Wayne
      Car FINALLY home !!!!!! lol
      Project FNQUIK https://www.pro-touring.com/showthre...ghlight=FNQUIK

    3. #3
      Join Date
      Oct 2011
      Posts
      467

      Ricks (Resto Mod) new EFI fuel tank

      Hello
      Believe I sold you your T56 transmission
      Are you worried about rust or corrosion in your tank using E85?
      I will be using E85 as well
      Have Rick Valley fabricating a staibless tank
      I am using a dual pump Aeromotive phantom setup (using twin 340lph E85 version pumps)
      There is a flex fuel sensor made for the LS3 I am using as well

    4. #4
      Join Date
      Nov 2009
      Location
      Austin Texas
      Posts
      640
      Yep that was me. I told Ricks what I was using it for and they didnt say anything so Im willing to bet its fine. I did run all PTFE lines though which was a pain.

    5. #5
      Join Date
      Jun 2001
      Location
      Newbury Park, CA
      Posts
      5,839
      Country Flag: United States
      vaporworx has just completed validation testing on the Walbro 450lph pump. The PressureWorx pwm controller works well with this pump when set up in a staged arrangement. In other words, a primary pump that runs whenever the engine is on, and a secondary that is turned on via a relay + Hobb's switch at the appropriate load. Up to three 450's can be run this way.

      The only trick is that a small bypass must be used to allow some fuel to flow at low fuel demand. Usually a 0.030" hole is sufficient and can be plumbed in through the return line. This similar amount of fuel is used in OE applications to drive the suction pumps.
      VaporWorx. We Give You Gas http://www.vaporworx.com

    6. #6
      Join Date
      Jan 2014
      Location
      Seattle WA
      Posts
      288
      Country Flag: United States
      Wonder how that setup will work. Assuming you wont be using a hobbs switch to activate the second pump. Aeromotive's dual set up has two outlets. One for each pump. Seems that it would be much easier to isolate them and run the switch.
      1967 El Camino 408ci LSx....and the build begins!
      1967 Turbocharged 408ci LSx Chevelle - 1012 rwhp, 959 rwtq 67 Chevelle
      2009 Supercharged Silverado - On the Dyno

    7. #7
      Join Date
      Jun 2001
      Location
      Newbury Park, CA
      Posts
      5,839
      Country Flag: United States
      Since those pumps have a check valve they are essentially blind to the system until they come on. Port the outlet of each pump to a "Y" block, then a single AN8 to a filter, then to the fuel rail.
      VaporWorx. We Give You Gas http://www.vaporworx.com




    Advertise on Pro-Touring.com