Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 4 of 4
    1. #1
      Join Date
      Mar 2011
      Location
      st. louis
      Posts
      96
      Country Flag: United States

      seam sealer points

      I just finished blasting and priming the underside of my 69 firebird, my problem is I stripped the car a long time ago (years) and cant remember every point where the seam sealer was applied, is there a diagram somewhere that shows points of application? or if anyone knows that help would be great.
      Thanks Bill



    2. #2
      Join Date
      Mar 2013
      Location
      Beaufort,SC
      Posts
      329
      Country Flag: United States
      Just seam seal any spot the water can get in.

    3. #3
      Join Date
      Mar 2011
      Location
      st. louis
      Posts
      96
      Country Flag: United States
      I don't remember the rear frame rails sealed, or the fuel tank mounts.

    4. #4
      Join Date
      Aug 2004
      Location
      Greenville, IL
      Posts
      262
      Country Flag: United States
      Depends on if you are going with an "Original" restoration of not. If original, I can't help you there. If you are not worried about being factory original then I would deal every sheet metal joint on the underside. Anywhere moisture can get between two labels is potential problem. Same thing goes for the inside.
      Joe Marti
      86 Monte Carlo SS build thread
      65 Mustang Coupe
      00 WS6 Trans Am (wife's car)
      15 Silverado LTZ 4x4




    Advertise on Pro-Touring.com