Results 1 to 7 of 7
Thread: Fast Ecu (map / Tps)
Threaded View
-
09-24-2005 #3
Registered User
- Join Date
- Feb 2002
- Location
- Santee, CA
- Posts
- 387
FAST ECUs
Originally was targetting 6 pounds of boost with a 4" upper and 7" lower pulley (.57 Ratio), however I changed the pulley sizes to 2 7/8 by 5.5" (.52 ratio). Anyone know how to calculate the boost? or is this not enough information. I've tried getting answers from Whipple, but to say they've been un-helpful would be an understatement.
Originally Posted by camcojb
Well, I've had both on every FAST system I've done. There is something you lose with adding another thing, but it's not those items. How much boost are you going to run?
Jody
I'm curious what configuration causes you to lose something...can you elaborate. I'm running an MSD 8366 GM Distributor with an MSD 8226 GM Coil. The ECU is running closed loop in batch mode. I'm all ears to any concerns, warnings, suggestions, ...
On a different subject Jody....have you gotten the reverse light part of your tail lights figured out yet? I talked to someone a few months ago and they said you were working on getting the reverse light worked into the lents, but wasn't available yet. I'm dying to buy a set, but would like to get them with the reverse light.
Thanks......Eric
-
Reply With Quote
