Results 1 to 3 of 3
-
02-18-2014 #1
Registered User
- Join Date
- May 2005
- Posts
- 386
intermediate or short steering arms needed
I have noticed speedway motors, cpp and a guy on ebay that sells new steering arms that are stated to be the intermediate of the three sizes. I purchased a set of gm that was on David pozzi's site as the intermediates but turned out to be the longs like I already have. I would love to be able to find a set of these that won't run a fortune. On full lock under load my wheels inner lip flexes just enough to touch the tie rod. Outside of a 1/4" spacer the arms would be my only alternative. Any advice. Short arms would also allow me to run 17x9.5 on the front also
1968 Camaro Crossram EFI 385, TKO 600 fully REMed. 594 hp/576 tq-ft. ATX spindles, Speedtech control arms, Chassis Works G-Link on 12 bolt with REMed gears, Chassis Works mini tubs, 245/40-17 front, 335/35-17 rear.
-
02-20-2014 #2
Registered User
- Join Date
- May 2005
- Posts
- 386
No one can give any info or help on this?
1968 Camaro Crossram EFI 385, TKO 600 fully REMed. 594 hp/576 tq-ft. ATX spindles, Speedtech control arms, Chassis Works G-Link on 12 bolt with REMed gears, Chassis Works mini tubs, 245/40-17 front, 335/35-17 rear.
02-21-2014 #3
Registered User
- Join Date
- May 2000
- Posts
- 4,151
No one makes them. You either need to find an original set or run the spacer. I see no reason not to just run a spacer.
Reply With Quote
