Barrrf
10-01-2015, 04:42 AM
Here is the 1 good pic of the install I felt I could post up. Never mind the dents, I had the panels sitting against each other before I put them in. The dents in the seat are from my kids car seats. Thoughts on these? You'll notice no winder crank - I have a slot cut out of the subpanel for a push button, I just havent done the power window conversion yet.
Disclaimer: I used the wrong type of foam under the soft touch covers - so its already starting to separate. I'll have to pull the covers, refoam, recover. A project for winter time. But I think it'll look much better once theyre properly stretched. Question - are they too plain? Should I get an interior trim piece like Clayton Machine sells?
Panels out -
https://static1.pt-content.com/images/pt/2015/10/ObNxrGN-1.jpg
Panels In with Seat -
https://static1.pt-content.com/images/pt/2015/10/gobQp0ah-1.jpg
And here are the panels before I sanded, trimmed, filled, and covered them up -
https://static1.pt-content.com/images/noimg.gif
Disclaimer: I used the wrong type of foam under the soft touch covers - so its already starting to separate. I'll have to pull the covers, refoam, recover. A project for winter time. But I think it'll look much better once theyre properly stretched. Question - are they too plain? Should I get an interior trim piece like Clayton Machine sells?
Panels out -
https://static1.pt-content.com/images/pt/2015/10/ObNxrGN-1.jpg
Panels In with Seat -
https://static1.pt-content.com/images/pt/2015/10/gobQp0ah-1.jpg
And here are the panels before I sanded, trimmed, filled, and covered them up -
https://static1.pt-content.com/images/noimg.gif