Activity Stream

Kept moving forward with progress since there was a ton of stuff that I needed to do. I got the firewall all cleaned up and prepped for paint. I had...

I have set a goal that I think is pretty ambitious! Check out the video and see what it is! 🙂 secBKP17vuo

Before the headers got installed I needed to make some changes to the brake lines. The good news about this little project is I may have actually...

Price reduced to $38,000.

Contacted Millerbuilt, Jay said shims could theoretically be added between the housing and the floater end to add *up to* 1 degree of camber/toe...

Bot drifting around replying to old posts?

If the antenna has two motor wires, it reverses by switching polarity, so you need a DPDT momentary (on-off-on) rocker, not a plain on/off. Motor to...

Dying on the same timer every time sounds like security/PassLock or a lost ignition feed. Check that the PCM gets power in RUN (not only START) and...

I dove in and made good progress on the exhaust system after the previous detour. I didn't make flat rate but, I got the hardest part done. I'm sure...

Gotcha that makes sense. Sounds like itd be something to consider if I dive into road course at all.

Unfortunately at this point I had a self inflected set back. I got in a hurry and forgot to weld the inside of the old collectors before I welded...

Got this mostly done,I just need to run the red wire ign on to the original fuse block and wire up the gauges. Heres a picture of the LS swap...

You should write a book Donny! I’d buy a copy… :) Don

That would be awesome but in France we can't let something out of the hood

I guess someone got upset and deleted there posts? Having a discussion like this could help others when installing one with other harnesses...

No room for sweepers on a runway course and that is where the rear camber would really make the biggest difference.

I like the grill. But i also think it'd look sick with no grill, if the turbo was sticking out a bit!!! i might be bias cuz i got my charger stickin...

Not uncomfortable as I did it already. Just wondering why carl said to tap into the green #50, x1 black connector, spliced with the blue wire from...

Maybe you not understanding not like the psi picture with the fuse box. He specifically said tap into the green wire on the harness with the blue...

Chris bought it.

Yeah wish I would have known I could have just used the 60 psi pressure regulator the tech guy fron aeromotive said i needed to buy to use this gen5...

I hadn't thought about it like that, is it a layout design and venue size then? I will say it is rare I get a course layout with enough straightaway...

Carl said to tap into the fpr wire from pin#50 on the x1 black connector, which would be #85 Which is the green wire in the picture,if you are...

Looks great, good time to mini tub it!