Activity Stream

Not uncomfortable as I did it already. Just wondering why carl said to tap into the green #50, x1 black connector, spliced with the blue wire from...

Maybe you not understanding not like the psi picture with the fuse box. He specifically said tap into the green wire on the harness with the blue...

Chris bought it.

Yeah wish I would have known I could have just used the 60 psi pressure regulator the tech guy fron aeromotive said i needed to buy to use this gen5...

I hadn't thought about it like that, is it a layout design and venue size then? I will say it is rare I get a course layout with enough straightaway...

Carl said to tap into the fpr wire from pin#50 on the x1 black connector, which would be #85 Which is the green wire in the picture,if you are...

Looks great, good time to mini tub it!

- - - Updated - - - - - - Updated - - - - - - Updated - - -

Alright I got my vaporworx controller all wired in,and have some questions, I talked to Carl and he said I could splice into the green,with white...

SOLD...finally !!!

I wasn’t critiquing your driving or even your car. It was commentary on the site and course.

I'm on RT660's right now (legacy, non + version). The plan is, do the research for potential tires when the time comes I have to replace them....this...

Thanks! It's not up to date at present. For some reason I am unable to make changes to it.

I just noticed the list. Well done! 69 GTO 72 FIREBIRD 64 BONNEVILLE FUNERAL COACH 70 JAVELIN 52 F1 FORD PU 29 FORD PU

To give the driver's side header more clearance I got my girl Rosebud out and using a smal ball pien hammer and my really big channel lock pliers I...

I purchased a set of Sanderson headers for the truck. No question that running the factory manifolds with ported heads would be a waste of potential,...

Only you can decide worth. It might be worth it to you for any number of reasons......like if you're bored. I don't see value in it unless you are...

Interesting, that's a bit in the opposite direction of what I was expecting to hear about a cambered floater. Is this worth experimenting with at...

When I tried to assemble the optispark and install it I ran into a stripped external Torx head fastener. The E4 Torx hex(?) on the fastener is what...

In general, rear toe in will tighten the car up and toe out will loosen the car up. All the ones that I have cheated the camber on, I have always...

Thanks appreciate it

315 fits great up front long as the wheel is around 6" backspace, and the inner fenders are removed or modified because theyll rub the roof right...

This car is strictly race only, for that reason I have no problem going more aggressive with the alignment to gain as much grip from the tire as...