Activity Stream
-
Older Activity
-
2 Hours AgoBegan the cut / buff process... Let's hope I can finish this faster than the painting process. LOL79 replies | 40051 view(s) -
2 Hours AgoI’m amazed by what you accomplish while having a full time job and a family. :)265 replies | 132490 view(s) -
3 Hours AgoI haven't had much to update as I've only been driving the car and attending some car shows/cruise in's. Last weekend I decided to take my car on a...265 replies | 132490 view(s) -
4 Hours Ago1/2 Nicop will need a fairly large bend radius. Try to find a decent used dedicated 1/2 bender. Something like this...2 replies | 45 view(s)
-
12 Hours AgoWay back inna dawn 'o time, I used to use my knee to bend tubing. Bend it over a bit, shift, bend a bit, shift back, over and over until either the...2 replies | 45 view(s) -
15 Hours Agoanyone have any tips/advice on bending fuel lines? trying to run 1/2" feed with copper/nickel tube. i haven't had any luck with the tube wanting...2 replies | 45 view(s) -
16 Hours AgoNot too many photos make me slow down, soak in, and really appreciate the time, love, and craftmanship as these do. I tip my hat to ya, well done. I...57 replies | 30778 view(s)
