Activity Stream

Thanks appreciate it

315 fits great up front long as the wheel is around 6" backspace, and the inner fenders are removed or modified because theyll rub the roof right...

This car is strictly race only, for that reason I have no problem going more aggressive with the alignment to gain as much grip from the tire as...

With new heads, rockers, and lifters I needed to check the rocker arm contact patch on the valve tip just in case the old push rods were the wrong...

You may have noticed I got out of order with the posts. I've been condensing and organizing my posts from my original thread on the...

Little change before painting the hood, grill or no grill above the turbos ?

After a bunch of messing around I finally got the new cam degreed. It came in at 107.5 for a recommended 108 degree lobe centerline. I used the...

Before I went any further assembling the engine I wanted to replace the lower steering column bearing. It was worn to the point that it had a good...

Msg sent

Cool, very nice build! Good luck with the sale.

Is this this Forsale? Part Number

Anyone converted a variable displacement compressor to fixed by wiring the rear valve connector into the clutch's positive wire? It has two wires, do...

Love those valve covers. They'd look amazing on my car, hint hint.

Nice progress! Curious to see how those tires fit up front.

No sir I had this car build in the south west in Mexico Street toys MX looks them up took eight years to build

Weld wheels...18x12,18x10 Fits a 335 and 275. Complete car is for sale in the classified section. Believe there are pictures of the wheels....

you have any pics & specs on the wheels and tires? thanks

I've been enjoying the car for the last month or so after I fixed the cooling issues and upgraded the cooling fan. Been driving it back and forth to...

Nice work! Love to see another a-body build too. Trying to get the ambition on my 66 Buick to put the headliner in it and it’s ready to see the world!

When I bought the truck the PO mentioned I might want to change the crossmember, at time I didn't ask why however I did take a look at it later and...

Budget first: Previous total: 4461.16 New/corrected money: Rebought the wiring harness form auction for 36.50 instead of the original 73.99...

This car come out of WV? Local guy here built one like that several years ago. Just curious.

Good fortune blessed me back in April! I was unaware of it till doing some imagengineering on how to install a driveshaft loop. When I unpacked the...

After some careful grinding with my Dremel (On low speed, so it didn't get away from me! ) I got most of the casting flash removed. To finish I used...

You may be right about that. I hadn't considered that possibility. After taking a close look at the clutch fork I decided that it needed to be...

Was the dyno used to tune the engine or just see what the combo produced? It would be interesting to see the dyno stats if you have them, curves...

I'd guess your likely losing at least 25% to the turbo 400, camshaft is pretty tame for a 496 as well, but sounds like a great setup

Looking good!!!