Caddy Seville Rear End w/ disc brakes. 8.5 ten bolt will fit 67-69 Camaro, 68 up xbod

[pontiacmcl]

Got this in on trade the other day. Out of a 78-79 Seville. Same housing as a 67-69 Camaro or 68 up x body. It is complete disc to disc. One note of warning the axles have to be swapped or redrilled as they are 5x5 pattern and disc redrilled or use a set off of a late seventies WS6 Trans Am. It is the big (8.5")10 bolt so that is a great upgraded from the 8.2 that came in those. I am sure the gear is a 2.50?:1 or something close. It should be a posi trac but I have not removed the cover to verify. Located in East TN near Knoxville. Brakes would also be a direct bot on for a full sized 2wd Chevy Truck if you are interested in them but not the housing 250.00.

[mitch_04]

Do the brake calipers have e-brakes built into them? If so I'd be interested in purchasing them seperately.

[pontiacmcl]

They do have them built in, but I would rather sell as either a complete rear end or a complete brake assembly. The calipers are availabe at your local parts store. Naps's #s are CAL SE4691 (left) and CAL SE4692 (right)

[mitch_04]

I work at an auto parts store, they don't come with the e-brake lever on them. What are you looking to get for the complete brake assembly, and what does it all include?

[pontiacmcl]

The assembly would include the calipers with p.brake levers and cables, as well as the brake/backing plate assembly. The rotors they could have as well, but if they are doing a car, I would say save the shipping weight and buy some for a WS6. My cost at Napa for the calipers are roughly 75.00 each, but like you said no levers. Those pieces and the brackets are what are hard to come by. I say 200.00 + ride (about 30.00 to ship usps flat rate box or what ever ups would charge to where ever)

[mitch_04]

Thanks, but I'll have to pass.

[pontiacmcl]

Sold