Results 1 to 20 of 175
Thread: evilucy65
Hybrid View
-
12-01-2012 #1
Registered User
- Join Date
- Mar 2005
- Location
- Texan Back in Texas!
- Posts
- 676
Larger than 18x8 is going to be very difficult unless you stretch the tire. My 18x8 with 245 tire are a pretty tight fit at my low ride height. 18x11 will require relocating the framerails out back, an 18x12 becomes more difficult and would most likely require a whole new back-half to the car to give room. I will tell you , on these little Falcons a 315 tire on an 11" rim looks like a steamroller out back.
1965 Falcon Hardtop
However long you think your project will take, double it and you might be halfway right.
Build Thread: https://www.pro-touring.com/showthre...847#post798847
-
12-01-2012 #2
Registered User
- Join Date
- Jun 2012
- Location
- So Cal
- Posts
- 104
So far the test fitting the front end has gone well with it all fitting1965 Ford Falcon Blown and injected small block
2011 Mustang GT
1967 Bronco
2004 Dodge Diesel
07-13-2013 #3
Registered User
- Join Date
- Sep 2012
- Location
- Fremont, CA
- Posts
- 35
Nice project. Crossmember looks great!
Originally Posted by evilucy65
So far the test fitting the front end has gone well with it all fitting
07-13-2013 #4
Registered User
- Join Date
- Jun 2012
- Location
- So Cal
- Posts
- 104
Thank you, the only problem is its taking me forever to finish it
1965 Ford Falcon Blown and injected small block
2011 Mustang GT
1967 Bronco
2004 Dodge Diesel
07-13-2013 #5
Registered User
- Join Date
- Jun 2012
- Location
- So Cal
- Posts
- 104
I was alble to weld up some of the seams while I was the car with the welder
1965 Ford Falcon Blown and injected small block
2011 Mustang GT
1967 Bronco
2004 Dodge Diesel
Reply With Quote
