Unreal 1967 Mustang

[rusty428cj]

Rusty,

Is that roll bar from Mustangs to fear ? if so it looks like you welded it in as opposed to being able to unbolt it and remove it is that what you did?

How was fitment and are you happy with it?

We bought a Mustang to Fear roll bar but it did not fit right. The top center bend was not in the middle, the bar was twisted and the bends were not the same on both sides. We took a lot of measurements and the owner bought some new material and went to ART (Applied Racing Technology) in Clearwater Fl. with the original roll bar. They wanted to make it flat across the top but the owner wanted it like the Mustang to Fear bar but bent in the center. They put the dimensions in the computer and bent a new bar and it is almost perfect it's off a little at the bottom but the trim panel covers that.



It bolts in the front brace is welded to the bar.