Results 1 to 6 of 6
Thread: 69 camaro side markers
Threaded View
-
08-27-2004 #1
Registered User
- Join Date
- Aug 2004
- Location
- Montfort, Wisconsin
- Posts
- 15
69 camaro side markers
I have a question maybe a stupid one but I do not know much about welding but I have some sidemarker lights for a 69 camaro that would require me to cut some metal out of the fender and rear quarter panel but also on each corner where a sidemarker will go there will some filling in that is about 1/4"x1/4" on each corner where a light will go. So do I try to fill this area in with some welds then grind done or would it be best to try to cut a little peice out and weld in or is this impossible to do since it is such a small piece to weld in? If any one needs anymore info let me know your email address and I will explain more. I hope this is not to confusing but it is hard to explain without drawing it.
Thanks,
Custom69
-
Reply With Quote
