Project Demon Spawn: the rebirth of my 70' Duster-efi, 408ci, t56, dana 60

[ALLstrokedOUT]

I was thinking of painting the 'lip' around the grille the same metallic dark grey that the dusters was, not sure yet...all the front grille pieces are as they came to us.



And yes, i origianally ran Mallory HyFire 6AL and a Unilite pickup (retrofitted into a stock dist) on the Duster. I needed an advanceless distributor for the swap over, the unilite dist was in a box in the trunk of the duster when we bought it. I believe its supposed to be a big block dist, but after grinding ~1/4" off of the shaft that goes onto the timing gear/oil drive it fits great. Theres a section in the MS manual on running an MSD box, Its actually very simple with the unilite. In the tuning software you set a few different parameters up, tell it to look for a square wave signal, the input to the ecm is obviously from the unilite, output goes to the Hyfire box. Two wires compared to i believe 6ish to run a GM HEI with the MS...Hows your efi swap over going, arent you ready to swap over in the winter, rite?