Results 1 to 20 of 45
Thread: Installing Tru Turn
Hybrid View
-
08-31-2011 #1
Registered User
- Join Date
- Jun 2011
- Posts
- 53
might be a stupid ? but is there anything that the tru turn wont work with? certain spindles or anything?
-
08-31-2011 #2
Registered User
- Join Date
- Oct 2005
- Location
- Jasper,IN
- Posts
- 540
Oh, i'm sure there is. Might not work w/ DSE arms, sway bar and QA1's.....
Originally Posted by creekwood08
Looks like Mike is about to found out! I can't foresee any issues tho, the DSE uppers are designed to work w/ a tall spindle, so the ball joint angle should be ok.
Mike, one thing to check during installation is turning radius. With the TruTurn the steering stop contacts the front side of the ball joint plate. If the DSE arm is shaped much differently than our arm some modifications may need to be made to either increase or decrease turning radius.
09-07-2011 #3
Registered User
- Join Date
- Aug 2004
- Location
- Suisun City, Ca.
- Posts
- 792
Didn't Work for me
Well it didn't work for me. I am running a 383 SBC with hooker super comp headers. The relocated inner tie rods hit my header on the passenger side. I would have to reroute the header tubes in order to use this system. Not sure if other headers will work or not.
ridetech has been great help in trying to figure out a solution.Mike
Reply With Quote
