Results 1 to 3 of 3
Thread: harness hole first gen
Hybrid View
-
08-18-2011 #1
Registered User
- Join Date
- Aug 2004
- Location
- Holmes Hollow, Ontario Canada
- Posts
- 991
harness hole first gen
I posted this question over at Camaros as well yesterday but I need to get some ideas quick as my engine needs to go in on Sunday. I need some pics of where you cut the hole for your harness going through the firewall into your first gen f-body. I've got a 68, non ac. I know it has to go through near or behind the passenger head but there is the heater and duct work. To cut the hole I'm going to have to take all that stuff out again so it will be tough to know where to cut. If you have a picture of where you put your hole I would really appreciate it.
thanks
Scott
____________________________________________
Scott
-
08-19-2011 #2
Registered User
- Join Date
- Jan 2006
- Location
- Houston, Tx
- Posts
- 1,004
I used a hole saw to make mine... I'll try to get you some pics tonight. It was done so that my Vintage Air AC would still work without any issues.
Chris
08-19-2011 #3
Registered User
- Join Date
- Aug 2004
- Location
- Holmes Hollow, Ontario Canada
- Posts
- 991
I have a spot marked out to cut with the hole saw. It's going to be tight but its the only place I can put it. I'm mocking up the engine and trans first to make sure I'll have room. I imagine the vintage air would be close to the original duct work . Pics would be cool.
Thanks____________________________________________
Scott
Reply With Quote
