another ls pan question

[Tango68SS]

As Chris and others have stated.... The Mast pan is a super nice piece! I have sold and installed many of these since they have been out. They are a perfect fit in many applications. Been watching Chris.... Looking good bro!

Yeah Trav...too bad it took a while for you to be a Mast distributor... I bought my Mast pan as soon as the engine arrived at Brian's... BTW, the motor is in the car and we forgot to punch out the dip stick plug... Is it the one on the pax side and can we do it with the engine in the car??



TC

[daytonayellaz]

Yeah Trav...too bad it took a while for you to be a Mast distributor... I bought my Mast pan as soon as the engine arrived at Brian's... BTW, the motor is in the car and we forgot to punch out the dip stick plug... Is it the one on the pax side and can we do it with the engine in the car??

TC

Yea TC... its on the passenger side just forward of the starter in the block. You can do it with it in the car..... a little patience is required. Its basically a very small freeze plug. Im going to start sending out a sheet with the motors with this info on it to try and help solve this. Its very easy to over look this when doing the pan swap.

[Taylor1969]

Yea TC... its on the passenger side just forward of the starter in the block. You can do it with it in the car..... a little patience is required. Its basically a very small freeze plug. Im going to start sending out a sheet with the motors with this info on it to try and help solve this. Its very easy to over look this when doing the pan swap.

Yep... I had a minor freakout when I went to install the dipstick and there wasn't any hole to put it in

Punched it into the pan and spent over an hour digging it out . With the pan off it would have been a 30 second ordeal!

One of the many fun moments in the swap!

Chris

[Tango68SS]

Yea TC... its on the passenger side just forward of the starter in the block. You can do it with it in the car..... a little patience is required. Its basically a very small freeze plug. Im going to start sending out a sheet with the motors with this info on it to try and help solve this. Its very easy to over look this when doing the pan swap.

Thanks Travis! I'll make sure I let Brian know... I was at the shop yesterday and he is almost finished with a track car that needed to be done for a guy (bumped my car to the back burner). Brian should start hitting it this weekend!