Wheel stud install

[pedro]

I am putting longer studs in. The knurl dia is .615" and the hole in the axle measures .609". I am using a 1/2 drive breaker bar and washers to pull the stud thru.... how much effort should it take?? It seemed a little to easy since I could hold the axle to keep it from turning. I don't have anything to compare to except the front since I normally do this with an impact gun. The fronts were very difficult (.509" knurl and .495" hole, corvette hubs) Anythoughts would be apprecated before I go an put the rest in.

Second question, they are moroso studs 190,000 psi/8740 steel and they say not to use wheel spacers (which is the whole reason I am putting in longer studs) I don't see any issue running .5" hub and wheel centric spacers... concur?

Thanks

Pete