Results 1 to 12 of 12
Threaded View
-
12-31-2010 #1
Registered User
- Join Date
- Jul 2009
- Location
- Grand Rapids, MI
- Posts
- 1,559
Control arm/coil-over brackets...
Designing the brackets to mount my control arms and coil-overs. Is 1/8" okay or is 1/4" needed? I am running cross-shaft UCA's and figure a 1/4" plate will probably be needed for that but I'm not sure. I "thought" I've seen 1/8" used for most tabs or brackets and just want to confirm. I'll be running a tube through the front cross member that the inner LCA mounts will meet and will bring an outbound mount down from the frame rail for the outbound portion of the mount. What about coil-over mounts? Is 1/8" okay if it's boxed? Thanks guys.
-
Reply With Quote
