Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 11 of 11

    Threaded View

    1. #1
      Join Date
      Aug 2004
      Location
      Rustburg, Virginia
      Posts
      3,436
      Country Flag: United States

      Help with transfer case bearing clip

      What kind of trick is required to get the clip back on the output shaft bearing/tailshaft?

      I finished the pump rub repair and everything has gone flawlessly.....except this.

      I've had the case apart several times now and just cannot get that dang clip onto the groove on the bearing. I have purchased every set of snap ring pliers that Northern Tool carries and none of them are any good for spreading this clip(no holes in the clip). If I manage to get the clip spread it slipps off the pliers before I can get the bearing in place. I've been at this all stinking day and have made numerous trips into town buying different pliers of all shapes and sizes.

      1970 RS/SS350 139K on the clock:
      89 TPI motor w/ 1pc rear seal coupled to a Viper T56 via Mcleod's modular bellhousing w/ hydraulic T/O bearing from the Viper, 12 bolt rear w/ 3.73 gearing, SC&C upper control arms, factory lowers with Delalums, C5 brakes at all four corners, Front Wheels 17x8's with Sumi 255/40/17 and Rear Wheels 17x9's with Sumi 275/40/17.
      Brief description of the work done so far can be found here: http://www.nastyz28.com/forum/showthread.php?t=112454






    Advertise on Pro-Touring.com