Results 1 to 3 of 3
Threaded View
-
10-20-2010 #1
Registered User
- Join Date
- Aug 2004
- Location
- Rustburg, Virginia
- Posts
- 3,436
Tips for removing the color from welded stainless steel
Anyone have any good tips for removing the oxidation color from stainless steel after you have welded on it?
We had a project that had some A304 SS window lintels added to our contract. These 3/8" thick plates were 30.5" wide x 30' long and were stitch welded with intermittant fillet welds to the main structural steel above. The heat from welding had oxidized on bottom (opposite) side of these plates and the Architech on the job asked us to address this.
A trip to the grocery store proved to be fairly beneficial. I found 100% lemon juice(citric acid) seemed to get the job done and is enviromentally friendly and not hazardous to your health when using it.
samples as welded...
samples cleaned, one with lemon juice and one with CLR
1970 RS/SS350 139K on the clock:
89 TPI motor w/ 1pc rear seal coupled to a Viper T56 via Mcleod's modular bellhousing w/ hydraulic T/O bearing from the Viper, 12 bolt rear w/ 3.73 gearing, SC&C upper control arms, factory lowers with Delalums, C5 brakes at all four corners, Front Wheels 17x8's with Sumi 255/40/17 and Rear Wheels 17x9's with Sumi 275/40/17.
Brief description of the work done so far can be found here: http://www.nastyz28.com/forum/showthread.php?t=112454
-
Reply With Quote
