Results 1 to 8 of 8
Thread: A-Body wiring harness
Hybrid View
-
03-20-2010 #1
Registered User
- Join Date
- May 2008
- Location
- Chicago
- Posts
- 609
While I would of loved to route the wires under the fender I can't. I put a heater delete plate from DSE in and I am running Vintage Air so the box and lines are running under the dash. It's funny the car is a 67 and in my opinion is large put there sure isn't a lot of room after you start installing stuff.
-
03-20-2010 #2
Registered User
- Join Date
- Feb 2008
- Location
- Chicago
- Posts
- 127
Do you think it would be possible to do what WMHJR did except have the loom exit out the fire wall under the vintage air lines?? By exiting the passenger compartment high (as he did) and exiting the firewall lower, you could creat a "drip loop" on the loom which would channel moisture down and out through the fresh air return. Obviously you would have to see if there is enough clearance between the firewall and the inner fender well to accomodate the loom.
Ken B.
65 GTO
67 Firebird vert
03-20-2010 #3
Registered User
- Join Date
- Aug 2008
- Location
- Pgh, PA
- Posts
- 2,177
Run it on the drivers side. It's just wire.
Reply With Quote
