Aluminum glovebox to mount ECU, MSD, electronics

[XLexusTech]

If he doesn't, I still have mine. Sold my 68 and never used it. Please PM me if interested. Thanks.

Pm sent

[Hooded]

Just wanted to see if anyone had one of these Aluminium Glove Box Mount for sale.

Thanks

[ryeguy2006a]

I'm glad that I found this thread. I was able to replicate this and install my Holley Terminator X. Thanks for sharing, although I realize that this thread is very old.

[Motobrewmaster]

I like this idea but did not want to completely lose my glove box. I modified the orginal glove box insert to fit around my ECU mounted on the original heater box. Not as nice as what many have done here but hopefully will work for me.

[2yellow69]

I think that is a pretty nice solution. Clean, simple, and you still have a usable glove box. Most people would never notice the change if the glove box was opened.

[Motobrewmaster]

It wasn't difficult. I was able to do it with folding and cutting in the right areas. Make sure to make tabs to fold over for stapling like the OEM. I stapled and glued the tabs in place. If you fold and cut (sharp thin blade is essential) it to make it seal the bottom edges you won't have any gaps for things to fall through. Here is a picture of the inside.

I mounted my OBDII port to the bottom so that it is out of the way but also easily accessible.

[Hooded]

Just checking again to see if anyone has one of these for sale. I like to ask every few years.

[Sinnister69]

I used a metal plate an mounted my holley ecu upside down. Still have ample glove box space

[Jk918]

Looking to do something similar, but make the glove box insert out of sheet metal vs cardboard. Figure a way to mount it, those cardboard glove boxes are only so strong.

[Sinnister69]

With the metal plate the cardboard is sandwiched between the ecu and plate
Its really sturdy

[Smoky68]

I know this is an old thread, but would you still happen to have one of these for sale? If so, please PM me. I’m struggling to find a place to mount my ECU.