Results 1 to 4 of 4
-
05-06-2009 #1
Registered User
- Join Date
- Mar 2006
- Location
- Buffalo N.Y.
- Posts
- 209
back of fuse panel/block question
hi guys , on the firewall where the wiring harness plugs into the fuse panel there are 2 plugs and inbetween them there is a bolt. I want to unplug the wires so I can clean and sand down around the area. Does this bolt come into play? Or do the wires just pop off on there own?......any info will help, I don't want to mangle anything. Thanks.
Jeoff J.
Jeoff J.
Buffalo, NY
69 Camaro convertible ~ 350ci. ~ T56
To all u guys with the knowledge.
My Ride: http://community.webshots.com/user/yukongt
-
05-06-2009 #2
Registered User
- Join Date
- Aug 2005
- Location
- Patterson, NY
- Posts
- 784
The bolt holds the plugs to the fusebox. To remove the connector you must remove the bolt. Then, you can disconnect the two halves of the wiring harness connector.
One half is for the engine wiring, and the other is for lighting, wipers, etc.Jason Scheer
05-06-2009 #3
Registered User
- Join Date
- Mar 2006
- Location
- Buffalo N.Y.
- Posts
- 209
Thats
Jeoff J.
Buffalo, NY
69 Camaro convertible ~ 350ci. ~ T56
To all u guys with the knowledge.
My Ride: http://community.webshots.com/user/yukongt
05-06-2009 #4
Registered User
- Join Date
- Mar 2006
- Location
- Buffalo N.Y.
- Posts
- 209
Oops..!! Thats what I needed to know. Thanks Jason.
Jeoff J.
Buffalo, NY
69 Camaro convertible ~ 350ci. ~ T56
To all u guys with the knowledge.
My Ride: http://community.webshots.com/user/yukongt
Reply With Quote
