Enter your username:
Do you want to login or register?
  • Forgot your password?

    Login / Register




    Results 1 to 3 of 3
    1. #1
      Join Date
      Oct 2004
      Posts
      2,624
      Country Flag: United States

      Camshaft lobe appearance HELP!?

      This is a bit embarrasing to say it's been well over a decade since my last cam swap. I just bought a Summit "brand" hydraulic flat tappet camshaft.

      The cam bearing surface appears like bare shiny metal. But the lobes have a light gray appearance. Rubbing my finger across, I'd say the surface is not as smooth either (smooth, but not as smooth). I expected them to appear the same. Is this normal? Is it a new coating?

      I'm afraid to put it in with all the recent camshaft lobe wear issues floating around.

      Unfortunately my printer is dead, so I can't upload pics.

      Thanks.

      Red Forman: "The Mustang's front end is problematic; get yourself a Firebird."


    2. #2
      Join Date
      Jul 2006
      Location
      Hesperia, CA
      Posts
      29
      Very typical if this is a non-billet roller. This is normal. Just make sure you use some sort of zinc additive for the break in.
      Dale Lee
      Dale's Speed
      www.dalesspeed.com

    3. #3
      Join Date
      Apr 2008
      Location
      Newark, OH, / Concord, NC
      Posts
      497

      Cam lobes

      the coating is normal, just make sure that you also use a good assembly lube on both the lobes and lifters. When you are ready to start the engine make sure that the engine is set up start right away and stay running at 1800-2000 rpm for 20 minutes (timing, water, fuel ect) also prime the engine oiling system and if it doesn't start right away figure out why, cranking and cranking an engine that has a new cam is harder on the cam than anything else, good luck !

      -Dale


    Advertise on Pro-Touring.com