Shaved bumpers

[toxicz28]

I read about this in a magazine a few (10) years ago, and this is how I'll be doing it when the time comes. Cut the heads off of the bumper bolts (leave the square shank). Place a washer and nut on bolt to hold position in bumper hole. Weld from outside and smooth when finished. Prep for whatever finish you are going for ie. chrome, paint, powder. A few tips; remove chrome from weld area as not to contaminate weld. Use mild steel bumper bolts, not stainless steel. You can weld stainless and mild together, but you would have to use stainless wire to do so. The holes you will be filling, are square holes, so bolt position is not an issue.



Good luck with it!