Results 1 to 5 of 5
Hybrid View
-
12-19-2008 #1
Registered User
- Join Date
- Feb 2007
- Location
- USA, TN
- Posts
- 850
There are alignment holes at the front body mounts. To properly align the frame requires cross measurements to the reference holes at the rear spring eye mounts. Two inches off is a lot. You may get an inch of movement in the frame, but I don't think you will get two inches. Do you have the correct motor mounts? Are you using big or small block engine stands? Did your LS kit come with different engine stands?
-
12-20-2008 #2
Registered User
- Join Date
- May 2005
- Posts
- 386
If you still need these PM me and I can send you a copy of the actual Fisher Body drawing with the measurements. by the way don't use 69 measurements if you find them, they are different, I found out the hard way.
1968 Camaro Crossram EFI 385, TKO 600 fully REMed. 594 hp/576 tq-ft. ATX spindles, Speedtech control arms, Chassis Works G-Link on 12 bolt with REMed gears, Chassis Works mini tubs, 245/40-17 front, 335/35-17 rear.
Reply With Quote
