Camaro repro quarter ???s

[nkopper]

Hey guys,

I'm about finished fitting the passenger quarter on my '69 Camaro, but have a few minor fitment issues to resolve first. The repro quarter fits really good, but it bows out around the bottom of the door jam and won't sit flush with the rocker panel. The pics should show this better than I can explain it. Is there a relatively easy fix for this? I may try to put a self-tapping screw into the rocker, but would like to avoid putting a hole in the rocker if possible. When I bend it in where it needs to go, the quarter ends up about 1/8" too high at the top of the door.

Also, the body lines around the tail pain seem too low. Is this common with repro quarters? The upper misalignment is covered by the bumper, so I'm not too concerned about it, but the bottom body line is fairly noticeable. Nothing I can't fix with a little welding, but want to be sure it's not an alignment problem.

Thanks,

Nathan