Results 1 to 8 of 8
Threaded View
-
08-05-2008 #1
Registered User
- Join Date
- Jan 2008
- Location
- Castro Valley, CA
- Posts
- 530
Engine Mounted but have misc problems
I test fitted my motor and I cant get both of the mounts to line up with the holes on the subframe. I tried absolutely everything but its off by about 1/2 inch. It wont go any lower since its hitting the poly engine mount.
I am using Prothane mounts on S&P plates.
Next problem... The tranny is very crooked in my trans tunnel. I cant even get my ATS crossmember to bolt on. Its off to one side instead of being right in the middle. Is this normal or is my subframe missaligned somehow?
Thanks
John S.
68 "Bloodline" Camaro in assembly...
Speedtech Sub, Alston G-Billet/Fab 9 rear, Ridetech coil overs, Moser axles, Fesler 19's, Lots of Anvil parts,Twin tubo LS3/T56, Carbon fiber manifold, and the list goes on and on..........
-
Reply With Quote
