1996 Impala MistreSS

[SSTuner]

Trey, here are some picture of the lift-off.

Step 1: I pulled the car under 4-post lift.

Step 2: After carefull measurements, I designed/built a cradle out of 2x2 steel that was bolted together after jacking the body off the frame. The 2x4 wood is in place to cushion the contact point on the body.

Step 3: Using the four post lift at it's lowest point, we ran some straps through the 2x2 steel and around the lift ramps.



Step 4-5: Use lift to seperate body.

Step 6: Remove wheels to lower frame onto wheel casters so it can be dragged out.