Has Anybody

[ProdigyCustoms]

I assume you are referring to ride height. The rockers and crossmember are the lowest point on the car. We actually cut the front off and raised the front frame a couple inches since this pic as it was only tacked in here. All the fuel / brake lines, etc run through the frame, also the exhaust is run through the tunnel. It is a full chassis so there is no subframe under the car, and being a perimeter frame, the floors are not raised. The car basically will have a belly pan bottom. We can go about a 5 rocker stance which is really low, and still have decent suspension travel, however it is set up to ride in the center of the suspension and have full travel at 6 1/2" ride height.
The car is on a rolling frame jig I built and is about waist high so it is at a good working height. That is an old pic, before the Florida hurricanes and commitments with my other business, so not much has happened. I will try to get some pics tomorrow, the fenders are done, as well as the roll bar. Now that Nubreeds car (the yellow 69 convertible) is off the rotisserie and painted, Prodigy can go on the rotisserie for under body welding and floors. It's ready for paint, just need about 40 hours under the car on the rotisserie.
The wheels are Jagarangs, we used them for mock up. We will be putting slightly bigger wheels / tires, 285 / 35 /18 fronts and 345 / 25 / 20s. I like a bit taller tire on 67 and 68s with the round wheel wells. I am trying to get Kris to design something new for wheels.
look for pictures tomorrow of Jagarang and Nubreed, both are coming along now that i am back in the shop.