Help!!

[absintheisfun]

I think I made a pretty big mistake...so don't laugh, I seek advice.

I went with LH and RH full length floor boards because the previous owner/builder put in horrible patches with tar and a little bit of weld. Couple that with the decay in the toe boards, it seemed to me a good idea to do that, rather than a full floor and new firewall.

So, got the passenger side in perfect. SOMEHOW, I welded in the driver side about 1/8" to 1/4" higher than the passenger side. I'm assuming this is a no-go situation and I'll have to go and get another driver side panel and cut out the old one.

Am I stuck with this only possibility? Is there anything else that I can do? If I leave it, will it be impossible to align and drive correctly (safely)?

HELP!??????

thanks

-mcw