First-Gen S10 Corner Carver

[novanutcase]

got one side done up to the muffler:




clearly the wrong way to use a hanger:


Anybody got a good way to support exhaust pipe from the side or the bottom? I also need a way to support it from a crossmember that is about 1/2" above the pipe.

trackrat, thanks for the pics...the maeir panhard for early mustang was the original inspiration for my design, I can't believe I had such a brain fart. I was trying to think of a way to bolt the tube in, when in reality, I can just weld a flange to the tube and bolt the flange.

Anybody have experience with Inland Empire? They are cheaper than Denny's but Denny's knew what they were talking about on the phone whereas IE had no clue. I asked what the critical rpm on a 4" aluminum was for 59" center to center...the "tech rep" tells me they spin balance everything at 9000+ rpm, it'll be fine. Fine my ass. As long as they build a good driveshaft I'll use them, but they have no clue what they're talking about.

Jerome

Looking good!

IE has a pretty good rep so I'm surprised they were clueless to your issue!

Maybe you can make a cradle for the exhaust?

John