Looking for a 5" tall 1350 or 1330 9" yoke

[funcars]

I've been calling all over the country to find a tall yoke (5 in long) to fit a 9" with a Daytona pinion support. I have a brand new 4" OD driveshaft with 1350 U-joints, but it's about 1 inch too short. A taller pinion yoke would solve my problem. I could run a 1350 or a 1330 (with a conversion u-joint). So far the only thing I've found close is a used tall 3R yoke. I've tried Strange, MW, Moser, Currie, etc. Anyone know a place I should try?

Thanks

[chicane67]

The only yoke longer than 3 7/8" (end to U-joint CL) is going to be an OEM tall yoke. No one makes the taller yokes... that is affordable anyway.

Mark Williams doesnt even make one... and they make everything.

Check your PM. I sent you two contacts that may have a tall yoke for a DPS on the shelf.

[chicane67]

Tex Racing has one available... P/N TRE2321

No idea on price, but they make a billet unit.

[funcars]

Unfortunately the Tex racing part is only 4 inches tall too. There is a 1330 truck yoke available in a 5" height that should work. I'll make sure to get a good u-joint.

Thanks