Results 1 to 4 of 4
Thread: Bump steer
Threaded View
-
11-20-2007 #2
Full Blown G-Machiner
- Join Date
- Sep 2004
- Location
- PA.
- Posts
- 935
You`re right. The picture is off. The angle of the tie rod would be fine if it were on the same horizontal plane as the LCA. With the tie rod roughly where it is the inner tie rod needs to go down or the outter one up. The lines drawn through the arms and tie rod should all converge at the same point screen left. I`ve had that same book for 15 years or more and never noticed that diagram was off,good catch! Mark SC&C
-
Reply With Quote
